The EAM1000 is a stepper / servo motor amplifier package. It is fully plug and play compatible with the current series of NI^TM motion controllers via the NI cable (186381).

Configurations can range from 1-4 axis, mixing stepper and servo motor amplifiers in a single package.

Configuration and selection are made easy with DAC’s Motion Solver Software 1.0

DAC features true seamless connectivity with the National Instruments^TM motion controllers.

• Direct connectivity to NI controller

• Easy connect screw terminals for limits and auxiliary I/O

• On board power supply provides user 5 or 24 volt power for inputs and outputs

• Supports sinking (NPN) or sourcing (PNP) sensor and limit switch inputs

• All limit switch, digital inputs and digital outputs are optically isolated

• Outputs can sink or source up to 0.9 Amps

• Custom drives for retrofit applications

• Add motors / gearboxes and actuators to complete your application

• Brushless servo sinusoidal commutation

• Custom motor cables with Ip65 connectors

• Add options relays or conditioners for special input and ouput applications

• Axis 1-4 (stepper or servo)

• Input power 95-132 VAC single phase, 60 Hz.

• Step Motor Amplifier

  • bi-polar chopper

  • 0.02 to 3.5 Amps peak

  • 170 volt motor bus voltage

  • Resolutions: 200, 400, 1000, 2000, 5000, 10000, 12800, 18000, 20000, 21600, 25000, 25400, 25600, 36000, 50000 & 50800

  • Protection: motor phase to phase & phase to ground, drive overtemp

• Servo Motor Amplifier

  • supports brushless motors (60/120 degree commutated with halls or encoder tracks)

  • supports brush commutated motors

  • 12 amps continuous / 20 amps peak

  • 800 watts continuous power (all axis combined) at 50% duty cycle

  • 140 volt motor bus voltage

  • Protection: motor phase to phase & phase to ground, drive overtemp